- The Heavy Duty Frame is constructed of structural 4″ x 4″ steel tubing welded into a unitized one-piece frame. All high stress areas are reinforced to resist bending and twisting.
- The Vertical Clearance between the chisel point and the bottom of the frame is 26″ or 32″ depending on the tine size.
- Tines are mounted 24″ apart on the 2 Bar units and 36″ apart on the 3 Bar units. Then they are staggered from front to rear with a spacing from the center of the unit yielding a 12″ pattern.
- The Rigid Tine Pivot Assemblies are used where rocks are not a problem. Available on 5′ and 7′ 2-Bar units only.
- The Spring Tine Pivot Assemblies feature dual springs made of ½” oil tempered steel for strength and durability. The spring mounts are cast with internal and external helicals that match the ends of the springs. As the spring is stressed, the load is distributed evenly out the entire length of the spring. This distribution aids in avoiding stress concentrations.
Similar Products
MODEL 62
Call for Pricing
Gangs are assembled in the factory and tightened to 750 ft. lbs. The...
MODEL 116/119
Call for Pricing
The Quadraseal Wheel Hubs are an exclusive ATHENS PLOW design for inc...
MODEL 47
Call for Pricing
Category I Hitch is ideal for small tractors with 25 – 30 HP. The h...
MODEL 287/288
Call for Pricing
Two Main Frames are available for the Model 287 to match different wi...
MODEL 93
Call for Pricing
Strong relube Quadraseal Ball Bearings on the Model 93 mean long life...
MODEL 153
Call for Pricing
The Spring Bearing Hanger on the 153 provides maximum strength withou...
MODEL 97
Call for Pricing
The frame of the Model 97 is constructed heavy and durable 4 x 4" ste...
MODEL 127/167
Call for Pricing
The Model 127 is the ideal weight and size for general purpose usage....